Knowledge

Maintenance

Peeling interior lining and tired upholstery

Forum members say that with age the vinyl lining of the cabin comes loose on nearly every Tonic 23, because the foam behind it turns to dust. Owners describe how they glued it back, painted the hull, or replaced it with other materials, and which glues failed.

Last updated October 23, 2026

The problem

The cabin sides and ceiling are covered in vinyl on a foam backing. With age the foam turns to dust and the lining hangs down. Forum members reported this in 2008 (naoned and suspended-7494, Hisse-et-Oh, 4 February 2008: it happens systematically with age, and also on the Brio), and owners again in 2017, 2021, 2023 and 2025:

  • patbzh (Hisse-et-Oh, 21 July 2017): the lining of his Tonic is in tatters.
  • batagrillic (Segeln-Forum, 31 October 2021) bought a 1987 boat with a strong smell. The yellow foam behind the PVC has disintegrated. He also sanded the wooden floor and gave it four coats of two-pack clear varnish, and treated the old cushions with an ozone machine (25 January 2022).
  • Annysail (Segeln-Forum, 16 October 2023) bought a 1990 boat with the original gelcoat cracked in places; she sanded and filled it, repainted, and found the lining coming off everywhere.
  • rababar (Segeln-Forum, 15 September 2025): the lining loosens in time and removing it is a huge job.
  • Apollo (Zeilersforum, 6 August 2026): on many old boats, and he thinks all Jeanneaus, the foam layer of the vinyl lining comes away; it cannot be re-glued, so all of it has to be replaced. Bert65 (7 August 2026) calls this a very hard job, and says to pick a boat where it has been done.

What owners did

  • Re-glue and batten. montonic (Hisse-et-Oh, 9 August 2017) re-glued his lining with neoprene glue, put small screws at the joints, and is adding battens (door and window joint covers) to hold it and hide the glue overflow. He finds it better looking than paint, and it insulates.
  • Strip to the hull and paint. patbzh (3 September 2020) refreshed his three years earlier. The worst part is removing the glue; then a bathroom paint (Castomerlin).
  • Full refit. golfhotel (1 September 2020) removed every piece of lining, because none held, and kept the old pieces as patterns. He thinks he will not put lining back in the toilet compartment or the aft cabin.
  • New laminate. ALEBA (3 September 2020) describes a British refit: strip, clean and degrease, lay new glass and polyester, then gelcoat, sand from grit 40 to 180, and a finishing gelcoat thinned and sprayed. The result is impressive and the job is not as long as you might think.
  • Wooden battens. pierre 2 the minimalist (3 September 2020) would not redo it in vinyl: he would use small battens of light wood wherever possible and cork in the curves.
  • New artificial leather. Lommy (Segeln-Forum, 25 January and 20 February 2022), writing about the Fantasia 27 (a bigger Jeanneau, not a Tonic), scrubbed off the foam residue, painted the hull, and covered the walls and ceiling in Gisatex artificial leather. He sewed the folded edges, after removing the foam backing there, took out the windows and fitted new ones because the old panes had gone brittle. The Gisatex glue was still tacky after several years where he had used it (he threw away 7 or 8 cans, at about 25 euros each) and he used Pattex spray adhesive. Odysseus (20 February 2022) had no trouble with the Gisatex glue if the instructions are followed exactly, and says it lasted 10 years; he would never use spray adhesive over large areas. robocut (18 February 2022) suggests self-adhesive vehicle-trim textile, which holds immediately but cannot be corrected.
  • One cause: leaking windows. Lommy (boote-forum.de, 17 September 2003), answering a Tonic owner with the same problem, described what he found on his Fantasia 27 (not a Tonic). Water had seeped down the foam back of the wall lining from leaking windows, which explained water in the boat all winter. The foam had turned to a crumbly, mouldy mass. To remove it he had to take out the entire interior, wearing a respirator and overalls. His wife sewed the visible edges of new pieces cut from the old ones. The Gisatex glue would not bond below about 18 degrees C and bonded at once above about 23 degrees C, and two months later the residue was still as soft as fresh chewing gum. The Tonic owner (buo, 24 September 2003) found the foam of his ceiling had dissolved and gone brittle, but the cloth was still in good condition, and asked whether he could just remove the foam and glue the cloth back.
  • Felt. matthias23 (Segeln-Forum, 19 January 2023) used the felt that camper-van builders line their vans with. It is elastic, so it follows curves, forgives rough joints, and is cheap. It comes self-adhesive in greys; he wanted beige, so he used a lot of spray adhesive.
  • Coating instead of lining. Steve_007 (Hisse-et-Oh, 1 March 2014), whose Tonic’s lining had completely collapsed, asked about Sajade, a textured coating applied with a spatula. geall (same day) found it a good product but said it can absorb up to 30 per cent of its weight in water, like a damp sponge. deleted-13772 asked about mould after a winter with little care. deleted-5271 had once made a lining from powdered paper pulp and vinyl glue on an old boat, which never moved. deleted-27673 (2 March 2014) planned to try Subermarine, a cork-based coating sprayed in two coats with a low-pressure gun, in his forward cabin.
  • A Segeln-Forum member who did this job (Käptn Iglu 88, 17 October 2023) warns against a toxic spray adhesive he used 30 years ago, and says wallpaper moulds. Today he would use wood.

horstj (21 January 2023, page 2 of the thread) used self-adhesive Asmussen felt after several tips for wall coverings turned out to be flops. It is workable, but for big pieces it helps to have someone who knows how to cut and glue without wrinkles, and large areas cannot be corrected. It can be pulled off in one piece, which he finds far better than foam products. The felt is thin and dries quickly, and the colour range is small. For real insulation, laminated or two-layer materials are needed. Marinero (20 January 2023) added that the felt itself does not mould but, like carpet or mesh, gives mould plenty of surface to cling to. On 19 October 2025 horstj repeated that he would remove the old lining and redo it in felt.

horstj and logrethino (26 January 2022) add that trade materials from upholstery and camper-van suppliers are the same as the yacht-chandlery ones without the “yacht” price.

Other interior options

Bert65 (Zeilersforum, 18 December 2018) believes the Tonic 23 came with a plain interior or a more luxurious one with wooden cupboards above the seats. Holgiman had the “comfort” interior and offered photos. Bert65 wanted to copy it and noted that 3-metre planks exist (at a high price), that the wood must bend, and asked how it is attached at the top.

Sources