Knowledge

Engine & electrics

The small plate under the hull, and whether the keel stub needs an anode

A Tonic 23 owner asked whether the small plate on the hull is an anode. Forum answers say it is probably an old radio earth plate, and two owners who fitted an anode to the cast-iron keel or stub (one of them on a Kelt, not a Tonic) regretted it. This is opinion from one thread, not a tested rule.

Last updated October 23, 2026

Source: one thread on Hisse-et-Oh (29 March to 6 April 2021). Treat it as a set of opinions.

The question

Mousse Kawan (29 March 2021) asked whether the small plate under the hull of his Tonic 23 is an anode, whether it is normal for it to be on the polyester hull, and whether it should be painted with antifouling.

Answers

  • Probably an earth plate. Sailortoun (29 March 2021) said it looks more like an earth plate and asked whether cables are connected to it inside. fritz the cat (30 March and 6 April 2021) says it is the earth plate used by Loran C, the radio-navigation system contemporary with the boat. Do not use it as an anode. That low-frequency system needed a good earth return. The plate is sintered bronze, whose porous surface adds up to several square metres. You can link the rigging to it to carry off static electricity. Antifouling is a porous paint; if you want the plate to work, keep it clean and brush it from time to time. He also notes that the plate could be replaced by an anode linked by a cable to the engine block and all the other submerged metals.
  • Anode on the keel or stub: two warnings. WTS (29 and 30 March 2021) welded two screws to his keel and fitted a profiled anode a centimetre from the surface. Two months later the surface under it had oxidised. He ground everything off, had a yard treat the keel, and was told that a Tonic does not need an anode. His boat stays on a trailer and is in the water for only a couple of months a year. estey (30 March 2021), on a Kelt 620 DL and not a Tonic, drilled the cast-iron stub to fit a rosette anode, though the stub had no corrosion. The boat went in late, and from early October the board was stuck. Ashore, the stub was badly damaged near the anode, outside and inside; pieces of cast iron about 3 mm thick had come away and blocked the board. He sanded, cleaned inside the stub, treated it with a rust converter (Ferose) and a primer (Primocon), then antifouling, and relaunched without an anode.
  • If you do fit an anode. Polmar (30 March 2021): an anode needs electrical continuity to work, and antifouling insulates, so do not paint it. An anode that is not consumed should make you ask why. gorlann29 (30 March 2021): a non-wearing anode can be impure; reputable foundries sell guaranteed anodes, and some web-shop ones can be useless.

The thread does not settle what the plate on his boat is. Ask a yard or an electrician to trace the cable before you paint over it.

Sources