Buyers’ threads often come back to this. Owners on several forums name the chainplates (the deck fittings for the shrouds) as the thing to check and reinforce on a Tonic 23. None of them gives a drawing or a load calculation, so treat this as a list of what was found and done, not a method.
What owners found
-
vrobert78 (Hisse-et-Oh, 21 July 2017) had trouble with the shroud chainplates and with one beaching-leg chainplate, and had both repaired at a yard in Minihic-sur-Rance. He posted a photo album of the work (see his post in the thread).
-
intermezzo (boote-forum.de, 8 October 2023) sailed a Tonic for some years on the Waddenzee and IJsselmeer. His chainplates were pulled out of the deck in a rough moment. They had been fixed with small washers in the deck structure only, with no link to the hull side or a bulkhead.
-
jeanmar (Hisse-et-Oh, 25 January 2015) had heard of a reinforcement problem under the chainplates and said to check it when buying. Ca d’Oro (same day) replied that it can be reinforced easily.
-
penloch (Hisse-et-Oh, 17 November 2018) says the standard Jeanneau beaching legs attach to the flush deck chainplates, and that for repeated beaching the force on the chainplate causes play and leaks into the cabin fairly quickly.
-
In a buyer’s thread about one boat for sale, T1mm (Segeln-Forum, 15 September 2025) noted that the centreboard boat still had its original chainplates, which he said should be reinforced with a plate under and above the deck. He also pointed to a listing where the chainplates had already been done.
-
fransb (Zeilersforum, 12 March 2018) mentioned a photo report of chainplate repairs on a French forum.
-
In a Segeln-Forum viewing thread (18 and 19 October 2025), a buyer found cracks in the laminate beside a chainplate, inside a boat in Leipzig, and threaded metal rods leading the loads down into the hull. Henning noticed on the photos that the gap looked as large as the exposed thread of the bolts, as if the deck had been pulled up. Odysseus guessed the rods were not original and that the original under-deck fixing had been pulled up, then changed. After phoning a Tonic owner, the buyer said the owner confirmed that this triangle is part of the central frame. He concluded that damage had happened at this known spot and had apparently been repaired professionally, after the damage rather than preventively. horstj (19 October 2025) said he does not know the Tonic well, but that on the Jeanneaus of that period he knows (his is a Microsail), a triangle of frame at each side and a mast support to the keelson take the rig loads, and that on his own boat he enlarged and reinforced this triangle because it moved too much in wind. Quallenschubser (19 October 2025) said the chainplates would be a priority job on that boat, and that once more is known about them it gives the buyer an argument in price talks.
Reinforcements described
- Stainless plates in the laminate. gilou-79 (Hisse-et-Oh, 8 April 2016), from memory: a small stainless plate of about 7 by 3 (units not stated, presumably cm) partly embedded in the polyester on each side of the interior reinforcement that the chainplate bolts go through.
- Stainless bracket. JLPIER (Hisse-et-Oh, 24 January 2022) says the chainplates on his boat have been reinforced, with a stainless angle bracket that takes the loads into the boat’s structure.
- Fresh laminate plus bracket. golfhotel (Hisse-et-Oh, 2 September 2020), refitting a DL, planned a laminated reinforcement passing under the bracket and picking up the chainplates, and to reinforce the beaching-leg chainplates at the same time.
- Tie rods. Kerhulcoq (Hisse-et-Oh, 2 September 2020) fitted turnbuckle tie rods.
- Backing plates inside the cabin of good size, under the leg chainplates (penloch, 17 November 2018).
Kerhulcoq repeats the advice in several threads: strengthen the chainplate anchorage (9 August 2019, 24 January 2022).
Where the rig sits
A newcomer asked why the shrouds attach slightly behind the mast. Two replies called it normal for a fractional rig with swept spreaders (horstj and Føx, boote-forum.de, 12 September 2023), and intermezzo said the aft position is needed for rig trim.
Before you buy
Owners say to check the chainplates when buying (jeanmar, Kerhulcoq, intermezzo above): the state of the fixings, and whether a reinforcement has been done and how. If the original fixings are still there, plan on reinforcing them.
The rig and its attachments carry the whole load of the boat under sail. Have them inspected, and any reinforcement designed or checked, by a boatyard or rigger.
Sources
- Hisse-et-Oh, “Le Tonic 23 est il un (le meilleur) choix dans mon cas” (in French): jeanmar and Ca d’Oro (25 January 2015); lulu937 (19 May 2026) also calls the chainplates the main flaw.
- Hisse-et-Oh, “TONIC 23“: gilou-79 (8 April 2016).
- Hisse-et-Oh, “Tonic 23 : Vous en pensez quoi?“: vrobert78 (21 July 2017); Soso56 (11 December 2024) asks for photos of chainplate repairs.
- Hisse-et-Oh, “TONIC 23“: Kerhulcoq (9 August 2019).
- Hisse-et-Oh, “Mise à jour d’un Tonic 23.“: JLPIER and Kerhulcoq (24 January 2022).
- Hisse-et-Oh, “plan des béquilles d’échouage du Tonic 23 DL“: penloch (17 November 2018).
- Hisse-et-Oh, “choix d’un voilier transportable confortable, suite refit du Tonic 23 DL“: golfhotel and Kerhulcoq (2 September 2020).
- Segeln-Forum, “Besichtigung Jeanneau Tonic 23 – Schwachstellen?” (in German; six pages): T1mm (15 September 2025), IchoTolot, horstj, Odysseus, Quallenschubser (18 and 19 October 2025).
- boote-forum.de, “Segelboot Tonic 23 – Position der Wanten” (in German): Burny, horstj, Føx (12 September 2023), intermezzo (8 October 2023).
- Zeilersforum.nl, “Klapzwaard Jeanneau Tonic zit vast” (in Dutch): fransb (12 March 2018).